- timing side knock sensor
- 2010619_timing_side.jpg (25.91 KiB) Zobrazeno 4946 krát
RemovingMake sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).
- 7055B54 under-engine guard - r r .
- 7040D12 engine front side cover (one) lh or rh - r r (left).
- 7040D14 engine bay rear side cover (one) lh or rh - r r (left).
- 1048B44 heat exchanger/manifold pipe - r r .
- 1088C40 thermostat- r + r .
- 1088C36 thermostat support - r + r .
- 7055B39 front additional wheel arch half (one), lh or rh, front element - r r .
- 1088D26 rigid intake pipe to water pump - r+r for versions with a/c .
- 1072B42 left hand or right hand inlet manifold (one) - r+r .
- 1072B12 intake manifold (one) lh or rh - r r and replace gasket (right)
1. Undo the bolt (1a) and remove the timing side knock sensor (1b).
Refitting ( Removing )
Fit the timing side knock sensor and fix it tightening the bolt to the recommended torque.
- 1072B12 intake manifold (one) lh or rh - r r and replace gasket (right)
- 1072B42 left hand or right hand inlet manifold (one) - r+r .
- 1088D26 rigid intake pipe to water pump - r+r for versions with a/c .
- 7055B39 front additional wheel arch half (one), lh or rh, front element - r r .
- 1088C36 thermostat support - r + r .
- 1088C40 thermostat- r + r .
- 1048B44 heat exchanger/manifold pipe - r r .
- 7040D14 engine bay rear side cover (one) lh or rh - r r (left).
- 7040D12 engine front side cover (one) lh or rh - r r (left).
- 7055B54 under-engine guard - r r .
Connect the negative (-) battery terminal.